1, check whether the wireless bridge is connected to the computer
Check that the computer network cable is connected to the LAN port of the wireless bridge. If the network port is loose, the wireless bridge configuration page cannot be opened. An intuitive manifestation is to see if the computer's LAN port has turned on. In the Windows system, if the local area network connection of the network neighbor is disconnected, please make sure all the network ports are connected or the network cable is in good condition.
2, to determine whether the computer and the wireless bridge must have the same network segment as the network segment in <br> <br> computers and gateways with, for example, if you use a mask of 255.255.255.0 and gateway IP is 192.168.8.1, then you The IP used must be unique and on the same network segment as 192.168.8.XXX.
Whether the wireless bridge and computer are on the same network segment can also be used to ping the wireless bridge through the computer's ping command, or use the ping command on the wireless bridge Linux terminal: ping 192.168.8.77 (assuming your PC's IP address is 192.168. 8.77)
The Ping command will get a response.
An IP address conflict on the network will cause the ping packet to become unstable, replace an IP, and then ping the conflicting IP to see if the ping packet is unstable.
3, check the computer configuration and browser
With Windows, when the configuration changes, it is best to run the arp-d command in the command window. It is used to immediately delete the ARP list in Windows because the speed of the computer to update the list is sometimes slow.
Automatic transmission fluid (ATF) is a type of hydraulic fluid used in vehicles with automatic transmissions. It is typically coloured red or green to distinguish it from motor oil and other fluids in the vehicle.
Atf Oil is generally replaced every 120,000 kilometers, and the severe driving conditions are replaced every 60,000 kilometers.
Atf Transmission Fluid must meet the following requirements when working in an automatic transmission:
a) The efficiency of transfer power is related to the viscosity and degree of foaming. Therefore, the viscosity and degree of foaming are required.
b) When ATF works in an automatic transmission, the internal operating temperature of the system can reach -40-170 ° C, the oil flow rate can reach 20m/s, and it is continuously contacting with non-ferrous metals and air, so the oil antioxidant performance is high.
c) When ATF works in the system, the friction and other friction of the bearing and gears in the system must also be lubricated with ATF, so the ATF should have a certain lubrication performance.
d) With the advancement of modern automatic transmission technology, its overall size continues to shrink, but at the same time, it must ensure that its speed and transmission power remain unchanged. Therefore, the larger the ATF proportion.
Automatic Transmission Fluid is developed specifically to meet the requirements of high -performance automatic transmissions. It is suitable for all automatic transmission that requires using the dexrin II specifications.
This product can also be widely used in occasions that require hydraulic transmission, including power steering mechanisms, hydraulic systems, etc., and are not suitable for the DEXRIN VI specifications.
1.Excellent high temperature and stability, prevent oxidation of oil oxidation and the production of sediments, and keep the gearbox clean.
2.Good anti -abrasion protection effects, effectively extend the service life of parts.
3.Improve the friction characteristics and ensure that the gearbox is sustainable and reliable.
4.Good stability, shifting is smoother.
Auto Transmission Fluid,ATF Oil,ATF Oil Transmission,ATF Transmission Fluid
Guangzhou Lidi Automobile Supplies Co., Ltd. , https://www.lambosscn.com