Saw cutting problem is not horizontal

When the sawing saw saws, the material under the saw sometimes has a situation where the cutting surface is not horizontal. There are many reasons for this. Let's take a look at the processing methods for the non-horizontal cutting problems caused by different reasons.

1. Saw feeding rack and supporting plate are not on the horizontal surface. Be sure to keep the level and make the workpiece flat.

2. The sawing workpiece may be too hard, the feeding speed is too fast, and the feeding amount is too large.

3, band saw blade may be damaged, replace the saw blade.

4. The distance between the work of the sawing machine and the left guide arm and the workpiece may be too far. Closer to the point, the left guide arm is the best 6-10 cm away from the workpiece.

5. It may be that the gap between the alloy block and the saw blade of the clip saw blade is too large, and the gap can be reduced.

6. The saw blade of the sawing machine is not tensioned and it is basically feasible to tension the saw blade.

After seeing the above problems after encountering problems, you can basically find the problem and adjust it. However, the specific handling of some problems is more troublesome. It requires experienced master trainers.