At present, the common standards work has been carried out on both sides of the strait, covering telecommunications, flat panel display, LED, solar photovoltaic, wind turbines and other five industries. Among them, the telecommunications industry is currently signing a cooperation memorandum for signing the 4G LTE common standard, but the flat panel display, LED, solar photovoltaic, wind turbines have been standard development results have emerged.
In addition to the electronics industry, the development of common standards for manufacturing is also the focus of the market, and the common specifications of wind turbines is one of them. The wind turbine is completed by the Taiwan Standards Inspection Bureau and the China General Administration of Quality Supervision, Inspection and Quarantine. At present, 40% of the small wind turbines produced in Taiwan are sold to the Chinese mainland market. In the future, Taiwanese products entering the Chinese mainland market are expected to pass quickly. Verification, and this set of standards may be extended to the Asia-Pacific region in the future, becoming a regional or even international standard.
There is no uniform standard in the LED lighting products market, which makes the competition in the LED industry more chaotic. Consumers are also attracted by low prices when they choose products, which leads to product competition and price wars, which is not conducive to the development of the industry. Common specifications for lighting products are urgently needed.
The formulation of common standards will effectively guide the benign development of five industries, especially the chaotic LED lighting industry can change the trend of price wars, and can enhance users' recognition of products, and promote the development of the industry and the popularization of efficient lighting. effect.
Ethylene Decomposition Furnace Anchor
There are many types of anchors, and high-holding anchors are commonly used on drilling platforms, as shown in Figure 1. The main feature of this anchor is that its gripping force can only be guaranteed when the pulling force is in the horizontal direction. If the pulling force has a vertical component, the gripping force is reduced, and the anchor claw will be pulled out of the ground. Experiments show that the grip force starts to decrease when the anchor handle is turned up by 6°, and the grip force decreases significantly when the anchor handle is turned up by 12°. Therefore, when mooring, the lower end of the anchor chain must be tangent to the seabed, otherwise there is a danger of running the anchor. Lifting the anchor is to use this feature, pull the anchor chain upward to lift the anchor handle, the anchor loses its grip, and finally breaks out of the ground.
Ethylene Decomposition Furnace Anchor,Refractory Casting Anchors,Anchors For Pre Heater,304 Stainless Steel Refractory Anchor
Puyu kiln technology (jiangsu) CO.,LTD , https://www.anchorpy.com